Target "Track: Peak"

This is a feedback-only target! It turns your feedback-capable controller into a VU meter by constantly reporting the current volume of the configured track to it.

In addition to connecting it with a LED ring or motor fader source (which should be obvious), it can also be used with a single LED to build a clipping indicator:

  1. Set Target Min to the minimum dB value that should make your clipping LED turn on. Leave Target Max at 12.00 dB.

  2. Make sure the Out-of-range behavior menu is set to "Min or max".

  3. If you have an LED that supports multiple colors, you will probably see a rainbow of colors flashing up which can be quite confusing. Use the feedback transformation formula x = ceil(y) to restrict the feedback to just two values: Min (0%) or Max (100%). You can then use Source Min/Max controls to adjust the off/on LED colors.

At the moment this target only reports peak volume, not RMS.